Clinical Research Directory
Browse clinical research sites, groups, and studies.
"Osseodensification Efficacy on Molar Septum Expansion in Immediate Molar Implant Placement
Sponsor: Ain Shams University
Summary
The ideal positioning of immediate implants in molar extraction sockets often requires the osteotomy to be in the interradicular septum, which can be challenging in some cases, with traditional site preparation techniques. Also, the alveolar ridge undergoes various remodeling processes following tooth extraction, resulting in hard and soft tissue loss which complicates prosthodontic rehabilitation. Immediate implant placement help preserve the alveolar ridge dimensions and buccal ridge contour. While osseodensification has shown promise in enhancing primary stability and bone microarchitecture, its clinical and microstructural effects in molar extraction sockets remain underexplored. Although there is ample documentation of information on the temperature that is generated during preparation of implant sites, there are no studies available in the literature comparing conventional drilling and osseodensification techniques; therefore, the present investigation was aimed at analyzing the efficacy of osseodensification compared to conventional drilling in terms of bone dimensions preservation , changes in bone architecture during implant site preparation and heat generation to define which technique can be safely applied to achieve the necessary implant primary stability without damaging the surrounding bone. Aim of the study: Is to compare the molar septum dimensions using osseodensification expansion versus the conventional drilling protocol and to assess the role of jumping gap grafting in preservation of the alveolar ridge dimensions and buccal ridge contour in addition to Evaluation of the effect of osseodensification on the bony micro-architecture and heat generation
Official title: "Osseodensification Efficacy on Molar Septum Expansion in Immediate Molar Implant Placement: A Randomized Controlled Clinical Trial
Key Details
Gender
All
Age Range
18 Years - 50 Years
Study Type
INTERVENTIONAL
Enrollment
80
Start Date
2025-09
Completion Date
2028-09
Last Updated
2025-08-11
Healthy Volunteers
No
Conditions
Interventions
Osseodensification
Septum width will be directly measured post molar extraction confirming the premeasure of the CBCT. Measurement will be recorded at the narrowest width of the septum. Implant site preparation starts with a pilot drill, in clockwise motion, in the center of the septum, until 1 mm deeper than the planned implant length. Densah® Burs (Versah, LLC, Jackson, MI, USA) were then sequentially used in OD mode (counterclockwise, drilling speed 800-1500 rpm, with copious irrigation) in small increments to gradually expand the osteotomy, until reaching the desired width for the planned implant diameter, Osteotomy diameter as a reflection of septum width expansion will then be directly measured and recorded after site instrumentation. Implants of adequate diameter (4, 4.5, or 5mm) and length (selected using preoperative CBCT) will be inserted in the prepared osteotomies to engage the bone apical to the socket, insertion torque will be measured using the torque wrench and ISQ values
conventional drilling
Septum width will be directly measured post molar extraction confirming the premeasure of the CBCT. Measurement will be recorded at the narrowest width of the septum. The initial (pointed) drill will be used to make a hole (starting point) in the interradicular bone to avoid slippage of the subsequent the drills in the socket of the remaining roots. The drills of increasing diameters will be used to complete the implant osteotomy according to manufacturer instructions. In case of limited interradicular bone volume, drilling will be made at the socket of mesial or distal roots. Osteotomy diameter as a reflection of septum width expansion will then be directly measured and recorded after site instrumentation. Implants of adequate diameter (4, 4.5, or 5mm) and length (selected using preoperative CBCT) will be inserted in the prepared osteotomies to engage the bone apical to the socket insertion torque will be measured using the torque wrench and ISQ values
Locations (1)
Ain Shams University
Cairo, Egypt