Clinical Research Directory
Browse clinical research sites, groups, and studies.
The Effectiveness of the Twin Block and Carriere Motion Appliances in Post-pubertal Patients and an Evaluation of the Impact of Class II Malocclusion and Its Correction on Oral Health-related Quality of Life
Sponsor: Aslam Alkadhimi
Summary
The investigators of this clinical trial aim to: * Compare the effectiveness and efficiency of Clark's Twin Block Appliance (CTB) vs Carriere Motion Appliance (CMA) in correcting Class II malocclusion when used in post-pubertal older adolescents, in terms of skeletal and dental change. * Evaluate potential negative oral health-related quality of life (OHRQoL) impacts during the active treatment phase with either CTB or CMA in post-pubertal adolescents. * Investigate the impact of Class II malocclusion on oral health-related quality of life (OHRQoL) in post-pubertal adolescents. Class II division 1 malocclusion is a dental condition where the upper teeth protrude significantly over the lower teeth. It is a common type of malocclusion observed in orthodontic practice, accounting for approximately 20-25% globally. Correcting Class II malocclusion in growing patients using functional appliances and Class II correctors is relatively predictable. In Ireland and the United Kingdom, the Clark's Twin Block (CTB) is the most commonly used functional appliance. The CTB consists of two components: one for the upper teeth and one for the lower teeth. These components are engineered to position the lower jaw forward, thereby promoting the desired dentoskeletal changes (moving the upper teeth back and lower forward). Another device used for Class II correction is the Carriere Motion Appliance (CMA). The CMA is gaining popularity as a treatment option for Class II malocclusion, inducing dental changes similar to those achieved with a CTB. However, uncertainty persists regarding the effectiveness of these appliances in older adolescents in the post-pubertal growth phase (aged approximately 14.5 years or above). Additionally, although both CTB and CMA are effective in growing patients in correcting dental and skeletal discrepancies, they may influence daily activities, comfort, and psychological aspects, which often results in poor compliance. Poor adherence to orthodontic treatment, whether with fixed or removable appliances, can lead to higher rates of treatment failure.
Official title: The Effectiveness of the Twin Block and Carriere Motion Appliances in Post-pubertal Patients and an Evaluation of the Impact of Class II Malocclusion and Its Correction on Oral Health-related Quality of Life: A Randomised Controlled Trial
Key Details
Gender
All
Age Range
14 Years - Any
Study Type
INTERVENTIONAL
Enrollment
88
Start Date
2026-03
Completion Date
2029-09
Last Updated
2025-12-18
Healthy Volunteers
No
Conditions
Interventions
CTB
The appliance will be used with the bite registration taken in maximum protrusion incorporating the following features: (1) Adam's clasps on all first premolars and first permanent molars, (2) three ball-ended clasps on the mandibular incisors, (3) midline expansion screw in the maxillary component, (4) blocks intersecting at 70 degrees, with a height of 5-6 mm in the premolar region. Patients will be instructed to wear the appliance full-time, except for eating, and during contact or water sports. Objective wear time in minutes will be recorded by a Theramon® microsensor (Handelsagentur Gschladt, Hargelsberg, Austria, or Forestadent, Pforzheim, Germany) placed in the maxillary component.
CMA
The appliance consists of rigid stainless-steel or acrylic bars bonded to the maxillary canines and first molars bilaterally. Elastics will be worn in a Class II pattern, from hooks on the maxillary canine to attachments on the mandibular first molar (bonded molar tubes). Anchorage in the mandibular dentition will be provided by an Essix-type retainer. Patients will be instructed to wear elastics full time except for eating and cleaning the teeth. The elastics protocol for the CMA appliance will be: Force 1 elastics (Henry Schein Orthodontics) that generate about 375 g of force that will be used during the first 6 weeks, changed to Force 2 elastics that generate about 540 g of force thereafter.
Locations (1)
Ashtown Gate HSE Orthodontic Unit
Dublin, Dublin, Ireland